[omniORB] Binding omniORB to a specific address

[Duncan Grisby]

On Tue, 2013-08-20 at 16:28 +0200, Sylvain Gault wrote:

[...]
> I read this, and this is not what I'm looking for.
> I know I can configure the published addresses and the listen addresses
> on the server side. I can also configure the endPoint to connect to from
> the client side.
> 
> But what I'm trying to configure is the local interface of the client
> side.

I see. The outgoing interface the client uses is determined by the IP
stack's routing setup. It's not something that omniORB has any control
over. Your operating system probably has a "route" command that lets you
configure it.

Duncan.

-- 
 -- Duncan Grisby         --
  -- duncan at grisby.org     --
   -- http://www.grisby.org --